• Elevator Hinge Installation RSS Feed

    by Published on 06/14/2002 06:38 AM
    1. Categories:
    2. b Chapter 3 - Canard/Elevator

    To install the elevator hinges, we aligned the vertical tabs to be flush with our marks from the previous section and verified that they were inline with each other with string. Also differing from what was stated in the manual, we received both left and right hinges, and aligned them with the vertical plated facing the outboard end so that the elevators can be removed later more easily.

    Next we drilled pilot holes in the fore hinge hole for alignment. Then take a square and project the line square to the trailing edge and drill the aft pilot hole. We then sanded the mating surfaces and secured the hinges with structural adhesive, and fastened them down with 1/8" pop rivets while curing.

    Once the hinges are attached, any circus training you might have had really comes into it's own, as you need to reach inside the elevator torque tubes and attach a MS21042-3 locknut to SM24693S-272 screws that you drill with a 3/16" bit as far aft as possible without going into the elevator foam, and countersunk it. A couple of extra hands are almost certainly required to accomplish this, as is a goodly bit of your preferred profanity, and 4' long 1/4" ignition wrench is handy too (the one at the factory was adequate, but it seemed to me someone had cut it about 4" shorter than would have been really preferable).


    Setting canard hinge arm locations during Head Start
    Hinge Arm Pockets - Marking Locations
    Creating the canard hinge arm pockets during Head Start
    Hinge Arm Pockets

    Elevator Hinge Locations

    Elevator Hinges

    Mounting Elevator Hinges

  • Central What's New

    bferrell
    Today

    Article: 2019 - N735D - Cabiroy - Velocity XL/RG - St. Cloud FL - 0

    The current word is an engine problem on take-off, but that Steve and Susan...

    User: bferrell
    bferrell
    08/17/2019

    Article: Flight 43 - I finally earn wings of my own

    A big day here in the old town. After weeks of wrangling with schedules and...

    User: bferrell